Workshop Accessories

A simple way to remove light surface rust

Abrasive Blocks are handy for cleaning up tools, hardware and small workshop parts. They give you a controllable abrasive surface for light rust, marks and grime without turning the job into a full restoration.

A fine abrasive mesh for rust and finish work

Mirka Abrasive Mesh is a 360 grit abrasive for removing light surface rust from tools or lightly cutting back between coats of finish. The 229 x 152 x 10mm pad gives you a practical surface for careful workshop clean-up and finish preparation.

A cleaner-cutting paper for sanding blocks

Mirka Proflex Sandpaper folds around sanding blocks without cracking and uses a strong backing that resists shredding. It cuts quickly while leaving a uniform scratch pattern, helping finishes look clearer and deeper.

A comfortable block for flatter sanding

The Precision Sanding Block gives sandpaper a steadier, more comfortable backing. It helps keep pressure even across the surface, making hand sanding feel more accurate and less improvised.

Clean timber plugs for tidier details

Plug Cutters let you make matching timber plugs for covering screw holes and refining small details. They give you a neater way to finish fixings without relying on generic dowel or filler.

A grippy layer for jigs, clamps and blocks

Cork Rubber adds grip and protection where timber meets a surface. It is a practical finishing material for vice jaws, clamps and sanding blocks that need to feel steadier in use.

A simple stop for repeatable blade projection

Protrusion Stops help set blade projection consistently before sharpening. They shorten the setup routine and give you a repeatable reference point, so honing can feel more predictable from one session to the next.

Clean holes for small workshop fittings

Forstner Cutters help drill cleaner, flatter-bottomed holes for project hardware and workshop details. They give you a more controlled result when ordinary twist drills would feel too rough for the job.

Sharp spares for marking knife work

Replacement Blades keep your marking knife cutting cleanly when an edge is past its best. They are a small, useful backup for layout work where a crisp line makes the next step easier.